Alinco - DJ-V57T

Alinco - DJ-V57T

144MHz 5W / 430MHz 4.5W
FM Handheld Transceiver
Double Your Radio Fun with this Tough Talker Dual Band HT!

Engineered for success, this dual-bander is packed with features:

•2m/70cm dual-band hand held transceiver
•Choice of 3 power output levels: High 5W(13.8VDC), Low 0.5W and user-selectable Mid-power (1-3W)
•Quick-write memory channel (Uses a single key touch to copy current VFO data to the Lowest number of memory channels available)
•Direct frequency input through illuminated keypad
•High-grade water-resistant materials compatible to IPX7
•Rugged polycarbonate body resists dirt and dust
•Great audio with large 40mm internal speaker
•Easy-to-read backlit alphanumeric display
•200 Memories, plus one call channel on each band
•VFO, Memory and Scan modes
•39 CTCSS tone squelch (encode + decode) and 104 DCS
•Search-scan (programmed scanning) available on each band
•Tone burst function (1000, 1450, 1750 and 2100Hz)
•Battery-drain function avoids memory effect
•Two-touch repeater-setting access
•Internal VOX
•Wire cloning capability
•SMA antenna port
•2-level attenuator
•DTMF encode and auto-dialer
* The IEC 60529/IPX7 is an European system of test specification standards for classifying the degrees of protection provided by the enclosures of electrical equipment. An IPX7 designation means that the unit withstands immersion in one meter (approx 3ft) of still water for up to 30 minutes. The factory guarantees this grade for 1 year provided all the jack covers are properly and securely closed. However, Please understand that unit is not an IPX8 (water-resistant) grade, NOT even IPX7 COMPLIANT (but compatible); water-pressure such as washing the unit with running water may cause damage to the unit and voids warranty. Never immerse the unit uselessly under the water. V/UHF signal does not propagate in water. If the unit is dropped in water, please pick it up immediately and wipe with a clean dry cloth.

For PDF file Click Here

SPECIFICATIONS

General

Frequency range:
[T: TX] 144 - 147.995MHz, 420 - 449.995MHz
[T: RX] 136 - 173.995MHz, 400 - 511.995MHz
[E: TX/RX] 144 - 145.995MHz, 420 - 439.995MHz

Modulation:
F3E (FM)

Frequency step:
5,10, 12.5, 15, 20, 25, 30kHz step

Memory channel:
200 memory channels in total + 1 call channel/band + 1 Repeater-Access parameter memory/band

Antenna impedance:
50ohm unbalanced

Frequency stability:
+/- 2.5ppm

Supply voltage:
DC 7.0 - 16.0V (EXT DC-IN)

Current consumption:
(Typical value)
TX at High power VHF 1.6A, UHF 1.9 @ 13.8V
RX at 500mW AF out: 250mA
Stand-by: 80mA
Battery-save ON: average 27mA

Temperature range:
Unit -10digC to 60digC (+14digF to +140digF) Battery packs: -10digC to +45digC (+14digF to +113digF)

Ground:
Negative

Dimensions:
58(W)x110(H)x36.4(D)mm (2.28"(W)x4.33"(H)x1.43"(D)) with EBP-63 w/o projection

Weight:
Approx.270g (9.6oz) with EBP-63 & antenna

Transmitter

Power output:
(Approx.value)
DC13.8V: 5W / 2W / 0.5W
Battery packs (7.2 - 7.5Vdc): VHF5W - UHF 4.5W / 2W / 0.5W

Modulation:
Variable reactance FM

Spurious emission:
-60dB or less

Max. deviation:
FM : +/- 5KHz NFM: +/- 2.5KHz

Mic. impedance:
2Kohm

Receiver

System:
Double-conversion super heterodyne

Sensitivity:
-14.0dBu (0.2uV) or less

Intermediate frequency:
1st IF 38.85MHz 2nd IF 450kHz

Selectivity:
-6dB: 12kHz or more -60dB: 35kHz or less

AF output:
More than 400mW (8ohm, 10% distortion) / Max 500mW

Specifications subject to change without notice or obligation. Specifications apply to Amateur Radio bands only. Permits required for MARS use. Product intended for use by properly licensed operators.